How To Proceed With Troubleshooting [12/2012 - ]: Procedure

Result: 

NEXT 

See step  2

Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2012 - 10/2015] , or refer to HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ]

Result: 

DTC is output 

GO TO CAN COMMUNICATION SYSTEM:  HOW TO PROCEED WITH TROUBLESHOOTING [12/2012 - 10/2015]  ,  HOW TO PROCEED WITH TROUBLESHOOTING [10/2015 - ] 

Result: 

DTC is not output 

See step  4

1. Check for DTCs.

   Refer to DTC CHECK / CLEAR [12/2012 - ] 

   Body Electrical > Main Body > Trouble Codes 

2. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [12/2012 - ] 

   Body Electrical > Main Body > Clear DTCs 

3. Recheck for DTCs.

   Refer to DTC CHECK / CLEAR [12/2012 - ] 

   Body Electrical > Main Body > Trouble Codes 

Result: 

DTC output reoccurs 

GO TO DIAGNOSTIC TROUBLE CODE CHART:  DIAGNOSIS SYSTEM [12/2012 - ]  

Result: 

DTC output does not reoccur 

See step  5

1. Refer to Problem Symptoms Table.

   Refer to PROBLEM SYMPTOMS TABLE [12/2012 - 10/2015] , or refer to PROBLEM SYMPTOMS TABLE [10/2015 - ] 

Result: 

Fault is listed in Problem Symptoms Table 

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE 

Result: 

Fault is not listed in Problem Symptoms Table 

See step  6

1. Operation Check.

   Refer to OPERATION CHECK [12/2012 - 10/2015] , or refer to OPERATION CHECK [10/2015 - 08/2016] , or refer to OPERATION CHECK [08/2016 - ] 

2. Terminals of ECU.

   Refer to TERMINALS OF ECU [12/2012 - 10/2015] , or refer to TERMINALS OF ECU [10/2015 - ] 

3. Data List / Active Test.

   Refer to DATA LIST / ACTIVE TEST [12/2012 - ] 

Result: 

NEXT 

See step  7

Result: 

NEXT 

See step  8

Result: 

NEXT 

END