LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 XLE, AWD >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> (Door / Hatch) (Service Information) (Except Hybrid) >> Back Door Opener Switch >> Removal [10/2015 - ] >> Procedure

Removal [10/2015 - ]: Procedure

  1. REMOVE BACK DOOR CENTER GARNISH 

    See step  1

  2. REMOVE BACK DOOR SIDE GARNISH LH 

    See step  2

  3. REMOVE BACK DOOR SIDE GARNISH RH 

    HINT: 

    Use the same procedure described for the LH side.

  4. REMOVE BACK DOOR TRIM BOARD ASSEMBLY 

    See step  4

  5. REMOVE POWER BACK DOOR SENSOR ASSEMBLY LH (w/ Power Back Door) 

    See step  5

  6. REMOVE POWER BACK DOOR SENSOR ASSEMBLY RH (w/ Power Back Door) 

    HINT: 

    Use the same procedure described for the LH side.

  7. REMOVE REAR LIGHT ASSEMBLY LH 

    Refer to PROCEDURE - Step 6

  8. REMOVE REAR LIGHT ASSEMBLY RH 

    HINT: 

    Use the same procedure described for the LH side.

  9. REMOVE BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 9

  10. REMOVE BACK DOOR OPENER SWITCH ASSEMBLY 
    1. Disconnect the connector.
      GTY568842Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the back door opener switch assembly.
scientia non olet · About LEMON Manuals