Removal [12/2012 - ]: Procedure
- PRECAUTION WARNING:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [12/2012 - ]
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [12/2012 - 10/2015] , or refer to INITIALIZATION [10/2015 - 08/2016] , or refer to INITIALIZATION [08/2016 - ]
- REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
Refer to PROCEDURE - Step 3 [12/2012 - 08/2016] , or refer to PROCEDURE - Step 3 [08/2016 - ]
- REMOVE DOOR ASSIST GRIP COVER LH
Refer to PROCEDURE - Step 5 [12/2012 - 08/2016] , or refer to PROCEDURE - Step 5 [08/2016 - ]
- REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
Refer to PROCEDURE - Step 6 [12/2012 - 08/2016] , or refer to PROCEDURE - Step 6 [08/2016 - ]
- REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 7 [12/2012 - 08/2016] , or refer to PROCEDURE - Step 7 [08/2016 - ]
- REMOVE REAR DOOR SERVICE HOLE COVER LH
Refer to PROCEDURE - Step 11 [12/2012 - 08/2016] , or refer to PROCEDURE - Step 11 [08/2016 - ]
- REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 12 [12/2012 - 08/2016] , or refer to PROCEDURE - Step 12 [08/2016 - ]
- REMOVE REAR DOOR QUARTER WINDOW GLASS LH
Refer to PROCEDURE - Step 13 [12/2012 - 08/2016] , or refer to PROCEDURE - Step 13 [08/2016 - ]
- REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
Refer to PROCEDURE - Step 15 [12/2012 - 08/2016] , or refer to PROCEDURE - Step 15 [08/2016 - ]
- REMOVE REAR DOOR GLASS RUN LH
Refer to PROCEDURE - Step 18 [12/2012 - 08/2016] , or refer to PROCEDURE - Step 18 [08/2016 - ]
- REMOVE REAR DOOR WITH MOTOR LOCK ASSEMBLY LH
Disconnect the connector.
- Using a T30 "TORX" socket wrench, remove the 3 screws.
- Move the rear door with motor lock assembly LH downward and pull the release plate out of the rear door outside handle frame.
*a Downward - Remove the rear door with motor lock assembly LH and cables as a unit.
- Remove the door lock wiring harness seal from the rear door with motor lock assembly LH.
- REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH
Refer to PROCEDURE - Step 24 [12/2012 - 08/2016] , or refer to PROCEDURE - Step 24 [08/2016 - ]
- REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY LH
Refer to PROCEDURE - Step 25 [12/2012 - 08/2016] , or refer to PROCEDURE - Step 25 [08/2016 - ]