Removal [12/2012 - 11/2013]: Procedure

PRECAUTION
NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Refer to PRECAUTION [12/2012 - ]
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [12/2012 - 10/2015]
REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL
Refer to PROCEDURE - Step 4
REMOVE NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY
Refer to PROCEDURE - Step 5
REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY
Refer to PROCEDURE - Step 6
REMOVE TELLTALE LIGHT ASSEMBLY
Refer to PROCEDURE - Step 4

REMOVE RADIO RECEIVER ASSEMBLY

Remove the 4 bolts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

for Radio Receiver Type

for Radio and Display Type

REMOVE NO. 1 RADIO BRACKET

Remove the 3 screws and No. 1 radio bracket.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

for Radio Receiver Type

for Radio and Display Type

REMOVE NO. 2 RADIO BRACKET

Remove the 3 screws and No. 2 radio bracket.

for Radio Receiver Type

for Radio and Display Type