LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 XLE, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Meter / Gauge / Display - Diagnostics - Introduction - (Except Hybrid) >> Meter / Gauge System >> Data List / Active Test [12/2012 - 10/2015] >> Data List / Active Test [12/2012 - 10/2015]

Data List / Active Test [12/2012 - 10/2015]

  1. DATA LIST 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Warm up the engine.
    2. Turn the ignition switch off.
    3. Connect the Techstream to the DLC3.
    4. Turn the ignition switch to ON.
    5. Turn the Techstream on.
    6. Enter the following menus:
      1. for Combination Meter: Body Electrical / Combination Meter / Data List / All Data.
      2. for ABS/VSC/TRC: Chassis / ABS/VSC/TRC / Data List / All Data.
      3. for Engine and ECT: Powertrain / Engine and ECT / Data List / All Data.
    7. According to the display on the Techstream, read the Data List.

      Body Electrical > Combination Meter > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Tail Relay SW Tail relay OFF or ON OFF: Headlight dimmer switch in neither tail nor head position
      ON: Headlight dimmer switch in tail or head position      		 -
      Tail Cancel SW Tail cancel switch OFF or ON OFF: Tail cancel switch off
      ON: Tail cancel switch on      		 -
      ODO/TRIP Change SW Steering pad switch (DISP) OFF or ON OFF: Steering pad switch (DISP) not pressed
      ON: Steering pad switch (DISP) pressed      		 -
      P-Seatbelt Buckle SW Passenger side seat belt buckle switch OFF or ON OFF: Passenger side seat belt unfastened
      ON: Passenger side seat belt fastened      		 -
      Vehicle Speed Meter Vehicle speed Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph) Almost same as actual vehicle speed -
      Engine Rpm Engine speed Min.: 0 rpm, Max.: 12750 rpm Actual engine speed -
      Coolant Temperature Engine coolant temperature 0 to 127.5°C (0 to 261.5°F) After warming up: 75 to 100°C (167 to 212°F) -
      +B Voltage Value Battery voltage Min.: 0 V, Max.: 25.5 V 11 to 14 V -
      Integrated value for Maintenance Oil maintenance information integrated value Min.: 0, Max.: 25500 (mile) Driving distance after performing oil maintenance reset procedure displayed for U.S.A.
      Fuel Input Fuel input signal Min.: 0 L, Max. 127.5 L Current fuel level displayed -
      Ambient Temperature Outside temperature Min.: -40°C, Max.: 87.5°C Almost same as actual outside temperature -
      Rheostat value Light control rheostat value Min.: 0%, Max.: 100% 0 to 100% -
      Oil Pressure Switch Engine oil pressure switch OFF or ON OFF: Engine oil pressure not low
      ON: Engine oil pressure low      		 -
      Turn Signal Switch (Right) Turn signal switch (right) OFF or ON OFF: Turn signal switch (right) off
      ON: Turn signal switch (right) on      		 -
      Turn Signal Switch (Left) Turn signal switch (left) OFF or ON OFF: Turn signal switch (left) off
      ON: Turn signal switch (left) on      		 -
      Hazard Flasher Switch Hazard warning signal switch OFF or ON OFF: Hazard warning signal switch off
      ON: Hazard warning signal switch on      		 -
      Turn Switch Signal (Full Turn) Turn signal switch (full turn) OFF or ON OFF: Turn signal switch (full turn) off
      ON: Turn signal switch (full turn) on      		 -
      Key Remind Sound Condition of key reminder buzzer sound Normal, Slow or Fast Customize setting displayed -
      Driver Side Seatbelt Warning Buzzer Condition of driver side seat belt warning buzzer OFF or ON Customize setting displayed -
      P-Seatbelt Warning Buzzer Condition of passenger side seat belt warning buzzer OFF or ON Customize setting displayed -
      Units By Region Condition of multi-information display unit km/l, MI/g or km/g Customize setting displayed -
      ECO Drive Indicator Zone The condition of the eco driving indicator zone display OFF or ON Customize setting displayed -
      ODO Display Time After IG OFF Setting Condition of the odo display time 30 s, 60 s, 600 s or OFF Customize setting displayed -
      Lane Change Flashing Times Setting Condition of the lane change flashing time 3, 5, 7 or OFF Customize setting displayed -
      Number of Trouble Code Number of DTCs currently stored 0 to 255 0 -

      Chassis > ABS/VSC/TRC > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Vehicle Speed Vehicle speed Min.: 0 km/h (0 mph), Max.: 326 km/h (202 mph) Almost same as actual vehicle speed measured using speedometer tester -

      Powertrain > Engine and ECT > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Engine Speed Engine speed Min.: 0 rpm, Max.: 16383 rpm 750 to 850 rpm: Idling with warm engine -
      Coolant Temp Engine coolant temperature Min.: -40°C (-40°F), Max: 215°C (419°F) 60 to 90°C (140 to 194°F): After warming up engine -
  2. ACTIVE TEST 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
    5. According to the display on the Techstream, perform the Active Test.

      Body Electrical > Combination Meter > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Speed Meter Operation Speedometer OFF, 0, 40, 80, 120, 160 or 200 (km/h or mph) Acceptable range (km/h or mph): [Control range → Speedometer display]
      for mph 
      • 40 → 40 to 43.5
      • 80 → 80 to 84.5
      • 120 → 100 to 125.5

      for km/h (for Canada) 
      • 40 → 38 to 42
      • 80 → 78 to 84
      • 120 → 119 to 125
      • 160 → 159 to 167
      • 200 → 199 to 209

      for km/h (except Canada) 
      • 40 → 41.7 to 46.2
      • 80 → 83.4 to 88.4
      • 120 → 125.1 to 130.6
      • 160 → 166.2 to 173.2
      • 200 → 207.7 to 215.7
      TachoMeter Operation Tachometer OFF, 0, 1000, 2000, 3000, 4000, 5000, 6000 or 7000 (rpm) -
      Fuel Meter Operation Fuel receiver gauge OFF, Sender E, Empty, Warning, 1/4, 1/2, 3/4, Full or Sender F -
      A/T Indicator Operation 1 Shift position indicator (L, 2, 3, 4, D, N, R or P) OFF, L, 2, 3, 4, D, N, R or P -
      A/T Indicator Operation 2 Shift position indicator (5, 6, 7, S, M or B) OFF, 5, 6, 7, S, M or B -
      A/T Indicator Operation 3 Shift position indicator (D) OFF or D -
      Indicat. Lamp Airbag SRS warning light OFF or ON -
      Indicat. Lamp Doors All Open Open door warning light OFF or ON -
      Driver Side Seat Belt Front seat belt warning light OFF or ON -
      Indicat. Lamp ABS ABS warning light OFF or ON -
      Indicat. Lamp Charge Charge warning light OFF or ON -
      Indicat. Lamp Slip Slip indicator light OFF or ON -
      Indicat. Lamp Coolant Hot Engine coolant temperature warning light OFF or ON -
      Indicat. Lamp Fuel Fuel level warning light OFF or ON -
      VSC TRC Indicator TRAC OFF indicator light OFF or ON -
      4WD Warning Indicator AWD warning light OFF or ON for AWD
      Indicat. Tire Pressure Warning System Tire pressure warning light OFF or ON w/ Tire Pressure Warning System
      Indicat. Oil Pressure Engine oil pressure warning light OFF or ON -
      Indicat. ECONO Eco driving indicator light OFF or ON -
      A/T Oil Temperature Operation A/T OIL TEMP warning light OFF or ON -
      Indicat. Lamp Cruise Cruise control indicator light (green) OFF or ON -
      Indicat. Lamp Brake Brake warning light OFF or ON -
      Indicat. EPS EPS warning light OFF or ON -
      Maintenance Indicator MAINT REQD indicator light OFF or ON for U.S.A.
      Indicat. Auto LSD AUTO LSD indicator light OFF or ON for 2WD
      Indicat. SET SET indicator light OFF or ON -
      Indicat. Sport(CVT Sport) SPORT indicator light OFF or ON -
      Indicat. VSC OFF VSC OFF indicator light OFF or ON -
      Indicat. ECO MODE ECO MODE indicator light OFF or ON -
      Indicat. 4WD Lock AWD lock indicator light OFF or ON for AWD
      Automatic High Beam Indicator Automatic high beam indicator light OFF or ON w/ Automatic High Beam System
      Cruise Indicator Cruise control indicator light (yellow) OFF or ON -
      Turn Signal (Left) Indicator Turn indicator light (LH) OFF or ON -
      Turn Signal (Right) Indicator Turn indicator light (RH) OFF or ON -
      Smart System Indicator Smart warning light OFF or ON w/ Smart Key System
      Smart System Warning Smart warning light OFF or ON w/ Smart Key System
      Blind Spot Monitor Indicator BSM indicator light OFF or ON w/ Blind Spot Monitor System
      LDA Control Indicator Lane departure alert indicator light (green) OFF or ON w/ Lane Departure Alert System
      LDA Warning Indicator Lane departure alert indicator light (yellow) OFF or ON w/ Lane Departure Alert System
      LDA Control Indicator (Left) Lane departure alert indicator light (green) OFF or ON w/ Lane Departure Alert System
      LDA Warning Indicator (Left) Lane departure alert indicator light (yellow) OFF or ON w/ Lane Departure Alert System
      LDA Control Indicator (Right) Lane departure alert indicator light (green) OFF or ON w/ Lane Departure Alert System
      LDA Warning Indicator (Right) Lane departure alert indicator light (yellow) OFF or ON w/ Lane Departure Alert System
      Water Temperature Meter Operation Engine coolant temperature receiver gauge OFF, LOW, NORMAL or HIGH -
      Meter Display 1 Multi-information display OFF, 0, 1, 2, 3, 4, 5, 6 or All -
      Meter Display 2 Multi-information display OFF, 7, 8 or 9 -
scientia non olet · About LEMON Manuals