LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 XLE, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System (Exterior) - Service Information - (Except Hybrid) >> Side Turn Signal Light Assembly >> Inspection [12/2012 - ] >> Procedure

Inspection [12/2012 - ]: Procedure

  1. INSPECT SIDE TURN SIGNAL LIGHT ASSEMBLY LH 
    1. Apply battery voltage to the connector and check the light illumination condition.

      OK

      Condition Specified Condition
      Battery positive (+) → Terminal 1 (B)
      Battery negative (-) → Terminal 2 (E)      		 Illuminates

      If the result is not as specified, replace the side turn signal light assembly LH.

      GTY361770Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Side Turn Signal Light Assembly LH)
  2. INSPECT SIDE TURN SIGNAL LIGHT ASSEMBLY RH 
    1. Apply battery voltage to the connector and check the light illumination condition.

      OK

      Condition Specified Condition
      Battery positive (+) → Terminal 1 (B)
      Battery negative (-) → Terminal 2 (E)      		 Illuminates

      If the result is not as specified, replace the side turn signal light assembly RH.

      GTY361770Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Side Turn Signal Light Assembly RH)
scientia non olet · About LEMON Manuals