LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 XLE, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Exterior Lights >> Lighting System (Exterior) - Service Information - (Except Hybrid) >> Rear Light Assembly >> Inspection [10/2015 - ] >> Procedure

Inspection [10/2015 - ]: Procedure

  1. INSPECT REAR LIGHT ASSEMBLY LH (for LED Type Taillight) 
    1. Apply battery voltage to the connector and check the light illumination condition.

      OK

      Condition Specified Condition
      Battery positive (+) → U23-1 (B)
      Battery negative (-) → U23-2 (E)      		 Taillight illuminates

      If the result is not as specified, replace the rear light assembly LH.

      GTY572891Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Rear Light assembly LH)
  2. INSPECT REAR LIGHT ASSEMBLY RH (for LED Type Taillight) 
    1. Apply battery voltage to the connector and check the light illumination condition.

      OK

      Condition Specified Condition
      Battery positive (+) → U24-1 (B)
      Battery negative (-) → U24-2 (E)      		 Taillight illuminates

      If the result is not as specified, replace the rear light assembly RH.

      GTY605164Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Rear Light assembly RH)
scientia non olet · About LEMON Manuals