Inspection [08/2016 - ]: Procedure
- INSPECT REAR SEAT INNER BELT ASSEMBLY LH
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1(LBR+) - 2(LBR-) Rear LH seat belt not fastened Below 1 Ω 1(LBR+) - 2(LBR-) Rear LH seat belt fastened 10 kΩ or higher *a Component without harness connected
(Rear Seat Inner Belt Assembly LH)If the result is not as specified, replace the rear seat inner belt assembly LH.
- Measure the resistance according to the value(s) in the table below.
- INSPECT REAR SEAT INNER BELT ASSEMBLY RH
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1(RBR+) - 2(RBR-) Rear RH seat belt not fastened Below 1 Ω 1(RBR+) - 2(RBR-) Rear RH seat belt fastened 10 kΩ or higher *a Component without harness connected
(Rear Seat Inner Belt Assembly RH)If the result is not as specified, replace the rear seat inner belt assembly RH.
- Measure the resistance according to the value(s) in the table below.
- INSPECT REAR CENTER SEAT LAP TYPE BELT ASSEMBLY RH
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition 1(CBR+) - 2(CBR-) Rear center seat belt not fastened Below 1 Ω 1(CBR+) - 2(CBR-) Rear center seat belt fastened 10 kΩ or higher *a Component without harness connected
(Rear Center Seat Lap Type Belt Assembly RH)If the result is not as specified, replace the rear center seat lap type belt assembly RH.
- Measure the resistance according to the value(s) in the table below.