Inspection [12/2012 - ]: Procedure
- INSPECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH
- When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.
If the operation is not as specified, replace the rear seat 3 point type belt assembly LH.
NOTE:Do not disassemble the retractor.
*1 Retractor *a Unlocked *b Locked *c 45° - w/ ALR:
Check the fastening function of the child restraint system.
NOTE:The check should be performed with the outer belt installed.
- When the belt is pulled out fully, the belt should automatically start to retract.
- After the belt has fully retracted, the belt should be able to be pulled out and retracted again.
If the operation is not as specified, replace the rear seat 3 point type belt assembly LH.
- When the inclination of the retractor is 15° or less, check that the belt can be pulled from the retractor. When the inclination of the retractor is over 45°, check that the belt locks.