Disassembly [12/2012 - 08/2014]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE FRONT DIFFERENTIAL RING GEAR

Put matchmarks on the front differential ring gear and differential case.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Matchmark

Remove the 12 bolts.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using a plastic-faced hammer, tap on the front differential ring gear to remove it from the differential case.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN

Secure the front differential case in a vise between aluminum plates.
NOTE:
Do not overtighten the vise.

Using a 5 mm pin punch and hammer, remove the front differential pinion shaft straight pin from the differential case.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NOTE:

Before removing the front differential pinion shaft straight pin, unstake it with a pin punch.

REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT

Remove the front No. 1 differential pinion shaft from the differential case.

REMOVE DIFFERENTIAL SIDE GEAR

Remove the 2 front differential pinions, 2 front differential pinion thrust washers, 2 differential side gears, and 2 No. 1 front differential side gear thrust washers from the differential case.

*1	Differential Case
*2	Differential Side Gear
*3	No. 1 Front Differential Side Gear Thrust Washer
*4	Front Differential Pinion
*5	Front Differential Pinion Thrust Washer

REMOVE TRANSAXLE CASE OIL SEAL RH (INNER)

Using SST, remove the transaxle case oil seal RH (inner) from the transaxle case.

SST: 09308-00010