Replacement [12/2012 - ]: Procedure

Refer to REMOVAL [12/2012 - 08/2017] Refer to REMOVAL [08/2017 - ] 

Refer to PROCEDURE - Step 4

1. Outer:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Protective Tape

   1. Using a screwdriver with its tip wrapped with protective tape, pry out the transaxle case oil seal RH.
      NOTE:

      Be careful not to damage the housing.

      HINT: 

      Tape the screwdriver tip before use.

2. Inner:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Using SST, tap out the transaxle case oil seal RH.
      • SST: 09308-00010 
      NOTE:

      Be careful not to damage the housing.

1. Inner:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Coat the lip of a new transaxle case oil RH seal with MP grease.
   2. Using SST and a hammer, tap in the transaxle case oil seal RH.
      • SST: 09950-60010 
        1. 09951-00410
      • SST: 09950-70010 
        1. 09951-07200

      Standard depth

      21.5 to 22.5 mm (0.847 to 0.885 in.)

2. Outer:

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Coat the lip of a new transaxle case oil seal RH with MP grease.
   2. Using SST and a hammer, tap in the transaxle case oil seal RH.
      • SST: 09649-1701009950-70010 
        1. 09951-07200

      Standard depth

      5.5 to 6.5 mm (0.217 to 0.255 in.)

      NOTE:

      Make sure that the transaxle oil seal RH is installed in the correct direction.

Refer to PROCEDURE - Step 2

Refer to INSTALLATION [12/2012 - 08/2017] Refer to INSTALLATION [08/2017 - ]