LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 SE, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Transfer Case (Service Information)) >> TRANSFER CASE FRONT OIL SEAL (for RH Side) >> Replacement [12/2012 - ] >> Procedure

Replacement [12/2012 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. DRAIN TRANSFER OIL 

    See step  1

  2. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH 

    Refer to REMOVAL [12/2012 - ]

  3. REMOVE DRIVE SHAFT BEARING BRACKET 

    Refer to PROCEDURE - Step 53

  4. REMOVE TRANSFER CASE OIL SEAL RH 
    GTY372893Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    *1 Transfer Case Oil Seal RH
    1. Using SST, remove the transfer case oil seal RH from the No. 1 transfer case cover.
      • SST: 09308-00010 
      NOTE:

      Do not scratch the press-fitting surface of the transfer case oil seal RH.

  5. INSTALL TRANSFER CASE OIL SEAL RH 
    GTY381326Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    *1 Transfer Case Oil Seal RH
    1. Using SST and a hammer, tap in a new transfer case oil seal RH as shown in the illustration.
      • SST: 09316-60011 
        1. 09316-00011

      Drive in depth (A)

      7.5 to 8.5 mm (0.296 to 0.334 in.)

      NOTE:
      • Tap the transfer case oil seal RH uniformly so that the transfer case oil seal RH is straight.
      • Do not tap the transfer case oil seal RH in too far.
  6. INSTALL DRIVE SHAFT BEARING BRACKET 

    Refer to PROCEDURE - Step 22

  7. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH 

    Refer to INSTALLATION [12/2012 - 08/2016] Refer to INSTALLATION [08/2016 - ]

  8. ADD TRANSFER OIL 

    See step  2

  9. INSPECT TRANSFER OIL LEAK 
scientia non olet · About LEMON Manuals