Replacement [12/2012 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE TRANSFER ASSEMBLY
Refer to REMOVAL [12/2012 - ]
REMOVE TRANSFER AND TRANSAXLE SETTING STUD BOLT
- for Transfer Side: (See step 1 See step 1 See step 1 See step 1)
- for Transaxle Side: (Refer to PROCEDURE - Step 37 Refer to PROCEDURE - Step 37 )
SECURE TRANSFER ASSEMBLY
See step 2 See step 2 See step 2 See step 2

REMOVE TRANSFER CASE OIL SEAL

Using SST, remove the transfer case oil seal from the transfer case.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Transfer Case Oil Seal

NOTE:

Do not scratch the press-fitting surface of the transfer case oil seal.

INSTALL TRANSFER CASE OIL SEAL

Using SST and a hammer, tap in a new transfer case oil seal as shown in the illustration.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*1	Transfer Case Oil Seal

Drive in depth (A)

9.5 to 10.5 mm (0.375 to 0.413 in.)

NOTE:

Tap the transfer case oil seal uniformly so that the transfer case oil seal is straight.
Do not tap the transfer case oil seal in too far.

REMOVE TRANSFER ASSEMBLY
See step 30 See step 30 See step 30 See step 30
INSTALL TRANSFER AND TRANSAXLE SETTING STUD BOLT
- for Transfer Side: (See step 31 See step 31 See step 31 See step 31)
- for Transaxle Side: (Refer to PROCEDURE - Step 10 Refer to PROCEDURE - Step 10 )
INSTALL TRANSFER ASSEMBLY
Refer to INSTALLATION [12/2012 - ]