LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 SE, FWD >> Repair and Diagnosis >> Engine Performance >> Testing & Diagnosis >> SFI System [2AR-FE] (Diagnostic Codes) (Except Hybrid) (6 Of 7) >> SFI System >> DTC P0451-P0453; Evaporative Emission Control System Pressure Sensor Range / Performance [12/2012 - ] >> DTC Summary

DTC Summary

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note
P0451 Evaporative Emission Control System Pressure Sensor Range / Performance Either of the following conditions is met:
  • Sensor output voltage fluctuates frequently in a certain time period.
  • Sensor output voltage does not vary in a certain time period.
  • Canister pump module
  • Connector/wire harness

    (canister pump module - ECM)

  • EVAP system hose (pipe from air inlet port to canister pump module, canister filter, fuel tank vent hose)
  • ECM
Comes on DTC stored DTC for Mexico Models
- Applies
P0452 Evaporative Emission Control System Pressure Sensor / Switch Low Input EVAP pressure sensor less than 42.11 kPa(abs) [315.867 mmHg(abs)] for 0.5 seconds.
  • Canister pump module
  • Connector/wire harness

    (canister pump module - ECM)

  • EVAP system hose (pipe from air inlet port to canister pump module, canister filter, fuel tank vent hose)
  • ECM
Comes on DTC stored DTC for Mexico Models
- Applies
P0453 Evaporative Emission Control System Pressure Sensor / Switch High Input EVAP pressure sensor higher than 123.761 kPa(abs) [928.331 mmHg(abs)] for 0.5 seconds.
  • Canister pump module
  • Connector/wire harness

    (canister pump module - ECM)

  • EVAP system hose (pipe from air inlet port to canister pump module, canister filter, fuel tank vent hose)
  • ECM
Comes on DTC stored DTC for Mexico Models
- Applies
DTC No. Monitoring Item Detection Timing Detection Logic
P0451 Canister pressure sensor abnormal voltage fluctuation
  • EVAP monitoring (ignition switch off)
  • Engine running
2 trip
Canister pressure sensor constant voltage
  • EVAP monitoring (ignition switch off)
2 trip
P0452 Canister pressure sensor low input
  • Ignition switch ON
  • EVAP monitoring (ignition switch off)
1 trip
P0453 Canister pressure sensor high input
  • Ignition switch ON
  • EVAP monitoring (ignition switch off)
1 trip

HINT: 

The canister pressure sensor is built into the canister pump module.