LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 SE, FWD >> Repair and Diagnosis >> Brakes >> Parking Brake System >> Parking Brake (Service Information) (Except Hybrid) >> Parking Brake Switch >> Inspection [12/2012 - ] >> Procedure

Inspection [12/2012 - ]: Procedure

  1. INSPECT PARKING BRAKE SWITCH ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.
      GTY374189Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      On
      Off
      STANDARD RESISTANCE

      Tester Connection Switch Condition Specified Condition
      Switch connector terminal - Switch body On (Shaft is not pressed) Below 1 Ω
      Off (Shaft is pressed) 10 kΩ or higher

      If the result is not as specified, replace the parking brake switch assembly.

scientia non olet · About LEMON Manuals