Installation [12/2012 - ]: Procedure

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect the cables to the backing plates and parking brake shoe levers.
   1. Pass the cables through the backing plates, and then connect the cables to the levers.

      Refer to REASSEMBLY [12/2012 - ] 

   2. Install the cables to the backing plates with the bolts.

      Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

2. Install the clamps to the trailing arms with the 2 bolts (labeled F).

   Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

   NOTE:

   Securely install the clamps.

3. Install the clamps to the rear suspension crossmember with the 2 bolts (labeled E).

   Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

   NOTE:

   Securely install the clamps.

4. Install the clamps to the crossmember with the 2 bolts (labeled D).

   Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

   NOTE:

   Securely install the clamps.

5. Install the clamps to the vehicle body with the 2 bolts (labeled C).

   Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

   NOTE:

   Securely install the clamps.

6. Install the casing caps to the vehicle body with the 2 casing cap bolts (labeled B).

   Torque: 6.0 N*m (61 kgf*cm, 53 in.*lbf) 

   NOTE:

   Securely install the casing caps.

7. Install the cable clamp (labeled A) to the parking brake cable and vehicle body.
   NOTE:

   Securely install the clamp.

1. Connect the 3 cable ends to the equalizer to install the equalizer.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PROCEDURE - Step 1

Refer to PROCEDURE - Step 4

See step  6

Refer to INSTALLATION [12/2012 - 10/2015] Refer to INSTALLATION [10/2015 - ]

Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)