LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 SE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission (U760E) - Service Information (1 Of 2)) >> Transmission Wire >> Installation [12/2012 - ] >> Procedure

Installation [12/2012 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL TRANSMISSION WIRE 
    1. Install the transmission wire onto the transmission valve body assembly with the bolt and lock plate.

      Torque: 10.8 N*m (110 kgf*cm, 8 ft.*lbf) 

    2. Coat a new O-rings with ATF, and install them to the temperature sensor.
    3. Connect the temperature sensor onto the transmission valve body assembly with the bolt and lock plate.

      Torque: 10.8 N*m (110 kgf*cm, 8 ft.*lbf) 

    4. Engage the clamp and connect the transmission wire.
    5. Connect the 7 connectors of the shift solenoid valve.
    6. Connect the connector of the transmission revolution sensor.
  2. INSTALL TRANSMISSION VALVE BODY ASSEMBLY 

    Refer to INSTALLATION [12/2012 - ] 

scientia non olet · About LEMON Manuals