LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 SE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission (U760E) - Service Information (1 Of 2)) >> Transmission Control Cable >> Installation [12/2012 - ] >> Procedure

Installation [12/2012 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY 
    NOTE:

    Before installing the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in neutral.

    1. Put the transmission control cable assembly into the cabin and connect the transmission control cable assembly with the 2 bolts.

      Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

    2. Connect the transmission control cable assembly to the bracket with a new clip.
    3. Connect the transmission control cable assembly to the control shaft lever with the nut.

      Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf) 

    4. Turn the nut of the transmission control cable assembly 180° counterclockwise. While holding the nut in place, push in the stopper until the stopper clicks twice.
      GTY365119Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Stopper *2 Nut
      *a Push in - -
      NOTE:

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable assembly will not be reusable.

      HINT: 

      If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

    5. Connect the outer part of the transmission control cable assembly to the shift lever assembly. Check that the stopper returns to the pulled-out position.
      GTY371665Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Stopper *2 Nut
      *3 Shift Lever Assembly - -
    6. Slide the slider in the direction shown in the illustration and pull out the lock piece.
      GTY375249Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Slider
      *2 Lock Piece
    7. Connect the end of the transmission control cable assembly to the shift lever assembly.
      GTY364989Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • Make sure that the lock piece is pulled up.
      • Push on the end of the transmission control cable assembly all the way to the base of the pin.
    8. Push the lock piece into the adjuster case and lock it.
      GTY365587Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Adjuster Case
      *a Push in
      NOTE:

      Make sure that the lock piece is completely locked by the slider.

  2. INSTALL AIR CLEANER CASE 

    Refer to PROCEDURE - Step 4

  3. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 
  4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 5

  5. INSPECT SHIFT LEVER POSITION 

    See step  1

  6. INSTALL FRONT CONSOLE BOX 

    Refer to INSTALLATION [12/2012 - 10/2015] or INSTALLATION [10/2015 - ]

scientia non olet · About LEMON Manuals