LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 SE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission (U760E) - Service Information (1 Of 2)) >> Transmission Control Cable >> Adjustment [12/2012 - ] >> Procedure

Adjustment [12/2012 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. ADJUST SHIFT LEVER POSITION 
    1. Apply the parking brake and move the shift lever to N.
    2. Remove the front console box.

      Refer to REMOVAL [12/2012 - 10/2015] or REMOVAL [10/2015 - ]

    3. Slide the slider of the transmission control cable assembly in the direction indicated by the arrow and pull the lock piece outward.
      GTY370518Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Slider
      *2 Lock Piece
      *a Slide
      *b Pull
    4. Install the end of the transmission control cable assembly to the shift lever assembly.
      NOTE:
      • Check that the lock piece is pulled up.
      • Install the cable end all the way to the base of the pin.
    5. Push the lock piece into the adjuster case.
      GTY365587Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Adjuster Case
      *a Push in
      NOTE:
      • Check that the park/neutral position switch assembly and the shift lever are in neutral.
      • Securely push in the lock piece until the slider lock is engaged.
    6. After adjusting the shift lever position, check the operation and function of the shift lever. If there is a problem, adjust the position again.
    7. Install the front console box.

      Refer to INSTALLATION [12/2012 - 10/2015] or INSTALLATION [10/2015 - ]

scientia non olet · About LEMON Manuals