LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 SE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission (U760E) - Service Information (1 Of 2)) >> Shift Lever >> Removal [12/2012 - ] >> Procedure

Removal [12/2012 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [12/2012 - 10/2015] or REMOVAL [10/2015 - ]

  2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY 
    1. Move the shift lever to N.
    2. Disconnect the end of the transmission control cable assembly from the shift lever assembly.
      GTY373817Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Pull out the stopper of the transmission control cable assembly.
      GTY370074Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Stopper
      *2 Nut
    4. Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever assembly.
      NOTE:

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable assembly will not be reusable.

  3. REMOVE SHIFT LEVER ASSEMBLY 
    1. Disconnect the 2 connectors and 4 clamps from the shift lever assembly.
      GTY381528Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 4 bolts and shift lever assembly.
      GTY363242Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals