LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 SE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission (U760E) - Service Information (1 Of 2)) >> Park / Neutral Position Switch >> Removal [12/2012 - ] >> Procedure

Removal [12/2012 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE AIR CLEANER CAP SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 3

  2. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY 
  3. REMOVE AIR CLEANER CASE SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4

  4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY 
    1. Remove the nut and transmission control cable assembly from the transmission control shaft lever.
      GTY384496Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the connector from the park/neutral position switch assembly.
    3. Remove the nut, washer and transmission control shaft lever from the manual valve lever shaft sub-assembly.
      GTY384508Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the 2 bolts and park/neutral position switch assembly from the automatic transaxle assembly.
      GTY384689Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Before removing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the manual valve lever shaft sub-assembly. Be sure to remove the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral switch cannot be reinstalled correctly.

scientia non olet · About LEMON Manuals