LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 SE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Automatic Transmission (U760E) - Service Information (1 Of 2)) >> Combination Switch >> Inspection [12/2012 - ] >> Procedure

Inspection [12/2012 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT COMBINATION SWITCH ASSEMBLY 
    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Switch Condition Specified Condition
      2 (MSW1) - 4 (MSW2) Combination switch (SPORT) on Below 1 Ω
      2 (MSW1) - 4 (MSW2) Combination switch (SPORT) off 10 kΩ or higher
      Fig 1: Combination Switch Connector End View
      GTY376905Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Component without harness connected
      (Combination Switch)

      If the result is not as specified, replace the combination switch assembly.

scientia non olet · About LEMON Manuals