Inspection [12/2012 - ]: Procedure

INSPECT PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

Using a dial indicator, measure the propeller shaft runout for the front side.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Maximum runout

0.4 mm (0.0157 in.)

If the shaft runout is more than the maximum, replace the propeller shaft.

NOTE:

Place the dial indicator on the center of the shaft, and perpendicular to the shaft.

Using a dial indicator, measure the propeller shaft runout for the rear side.

Maximum runout

0.4 mm (0.0157 in.)

If the shaft runout is more than the maximum, replace the propeller shaft.

NOTE:

Place the dial indicator on the center of the shaft, and perpendicular to the shaft.