Inspection [12/2012 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- INSPECT DIFFERENTIAL LOCK SWITCH
- Measure the resistance according to the value(s) in the table below.
*a Component without harness connected (Differential Lock Switch) Standard Resistance
Tester Connection Switch Condition Specified Condition 6 (GND) - 9 (B) Differential lock switch on (Push) Below 1 Ω Differential lock switch off (Release) 10 kΩ or higher
- Measure the resistance according to the value(s) in the table below.