LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> RAV4 Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Transfer Case (Service Information)) >> 4WD Control Ecu >> Installation [12/2012 - ] >> Procedure

Installation [12/2012 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL 4WD ECU ASSEMBLY 
    1. Install the 4WD ECU assembly with the bolt.

      Torque: 11.5 N*m (117 kgf*cm, 8 ft.*lbf) 

    2. Connect the connector.
  2. INSTALL HEATER TO REGISTER DUCT ASSEMBLY 

    Refer to PROCEDURE - Step 2 Refer to PROCEDURE - Step 2

  3. INSTALL DEFROSTER NOZZLE ASSEMBLY 

    Refer to PROCEDURE - Step 3 Refer to PROCEDURE - Step 3

  4. INSTALL UPPER INSTRUMENT PANEL 

    Refer to INSTALLATION [12/2012 - 10/2015] Refer to INSTALLATION [10/2015 - ]

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Refer to INITIALIZATION [12/2012 - 10/2015] Refer to INITIALIZATION [10/2015 - 08/2016] Refer to INITIALIZATION [08/2016 - ] ).

scientia non olet · About LEMON Manuals