Typical Enabling Conditions
ALL
| Monitor runs whenever the following DTCs are not stored | None |
P0365: EXHAUST CAMSHAFT POSITION SENSOR VERIFY PULSE INPUT
| All of the following conditions are met | - |
| Engine speed | 600 rpm or higher |
| Exhaust camshaft position sensor range check fail (P0367, P0368) | Not detected |
| Ignition switch | ON |
| Starter | Off |
| Battery voltage | 8 V or higher |
| Exhaust camshaft position sensor voltage | 0.3 to 4.7 V |
P0367 AND P0368: EXHAUST CAMSHAFT POSITION SENSOR RANGE CHECK
| All of the following conditions are met | - |
| Starter | Off |
| Ignition switch | ON |
| Time after ignition switch turned from off to ON | 2 seconds or more |
| Exhaust camshaft position sensor verify pulse input fail (P0365) | Not detected |
| Battery voltage | 8 V or higher |