Typical Enabling Conditions
ALL
| Monitor runs whenever the following DTCs are not stored | None |
P0340: CAMSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 1)
| Both of the following conditions are met | - |
| Starter | On and not starter on again |
| Minimum battery voltage while starter on | Below 11 V |
P0340: CAMSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 2)
| All of the following conditions are met | - |
| Engine speed | 600 rpm or higher |
| Starter | Off |
| Camshaft position sensor voltage | 0.3 to 4.7 V |
| VVT system misalignment | Not detected |
| Camshaft position sensor range check fail | Not detected |
P0342, P0343: CAMSHAFT POSITION SENSOR RANGE CHECK
| All of the following conditions are met | - |
| Starter | Off |
| Ignition switch | ON |
| Time after ignition switch turned from off to ON | 2 seconds or more |
| Battery voltage | 8 V or higher |
| Camshaft position sensor verify pulse input fail | Not detected |