On-Vehicle Inspection [12/2012 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION
1. Apply the parking brake.
2. Turn the ignition switch to ON.
3. Depress the brake pedal and check that the engine starts when the shift lever is in N or P, but does not start in any other position.
4. Check that the back-up light comes on when the shift lever is moved to R, but the light does not operate in any other position. If the operation cannot be done as specified, check the park/neutral position switch assembly for continuity.