Installation [12/2012 - ]: Procedure

1. Install the park/neutral position switch assembly to the control shaft.
2. Temporarily install the 2 bolts.

   HINT: 

   The bolts will be tightened to a torque specification during the park/neutral position switch assembly adjustment procedure.

3. Temporarily install the control shaft lever.
4. Turn the lever clockwise until it stops, and then turn it counterclockwise 2 notches.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

5. Remove the control shaft lever.
6. Connect the park/neutral position switch connector.
   NOTE:

   • Before installing the park/neutral position switch assembly, remove any dirt or rust on the installation portion of the control shaft. Be sure to install the switch straight along the shaft while being careful not to deform the plate spring that supports the shaft. If the plate spring is deformed, the park/neutral position switch cannot be reinstalled correctly.
   • After installing the park/neutral position switch assembly, confirm that the 2 protrusions on the switch are aligned.

Refer to ADJUSTMENT [12/2012 - ] 

1. Install the control shaft lever to the park/neutral position switch assembly with the nut and washer.

   Torque: 12.7 N*m (130 kgf*cm, 9 ft.*lbf) 

2. Connect the transmission control cable assembly to the control shaft lever with the nut.

   Torque: 12 N*m (122 kgf*cm, 9 ft.*lbf) 

Refer to PROCEDURE - Step 4

Refer to PROCEDURE - Step 5

See step  1