Removal [12/2012 - 08/2016]: Procedure

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Using SST and a hammer, unstake the staked part of the rear axle shaft nut.
   • SST: 09930-00010 
     1. 09931-00010
     2. 09931-00020
   NOTE:

   Loosen the staked part of the rear axle shaft nut completely, otherwise the screw of the drive shaft may be damaged.

2. While applying the brakes, remove the rear axle shaft nut.

1. Remove the 2 bolts, and disconnect the rear disc brake caliper assembly.
   NOTE:

   Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Refer to PROCEDURE - Step 14

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the bolt and disconnect the rear speed sensor from the rear axle carrier.
   NOTE:

   • Prevent foreign matter from attaching to the sensor tip.
   • Be careful not to damage the rear speed sensor.
   • Clean the installation hole and the surface for the speed sensor every time the speed sensor is removed.

1. Remove the 4 bolts and the rear axle hub and bearing assembly.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the 4 bolts from the rear axle carrier.
2. Using a plastic-faced hammer, remove the rear axle hub and bearing assembly LH.