Installation [12/2012 - ]: Procedure

1. Install a new rear drive shaft inboard joint shaft snap ring LH.

1. Align the matchmarks and connect the rear drive shaft to the axle hub
2. Apply MP grease to the splines of the rear drive shaft inboard joint assembly LH.
3. Align the splines of the rear drive shaft inboard joint assembly LH and, using a brass bar and hammer, tap in the rear drive shaft assembly LH.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   • Face the cutout section of the rear drive shaft inboard joint shaft snap ring LH downward.
   • Do not damage the oil seal during the insertion.
   • Do not strike the tip of the outboard joint with the hammer.

   HINT: 

   Determine whether or not the rear drive shaft assembly LH is completely tapped in by checking for changes in sound or the reaction force of the brass bar.

Refer to INSTALLATION [12/2012 - 11/2013] , or refer to INSTALLATION [11/2013 - ]

Refer to PROCEDURE - Step 7

Refer to PROCEDURE - Step 10

Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf) 

Refer to TEST MODE PROCEDURE [12/2012 - 10/2015] , or refer to TEST MODE PROCEDURE [10/2015 - 08/2016] , or refer to TEST MODE PROCEDURE [08/2016 - ]

Refer to ADJUSTMENT [12/2012 - 08/2017] , or refer to ADJUSTMENT [08/2017 - ]