Installation [12/2012 - ]: Procedure

1. Install the seat position airbag sensor to the seat slide position sensor protector with the pin as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1

   Pin

2. Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position airbag sensor.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Seat Position Airbag Sensor
   *2	Feeler Gauge
   *3	Seat Rail

   NOTE:

   • If the seat position airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position airbag sensor with a new one.
   • When installing the seat position airbag sensor, be careful that the SRS wiring does not interfere with or is pinched between other parts.

   HINT: 

   Be sure that the clearance between the seat position airbag sensor and seat rail is between 0.6 mm (0.0236 in.) and 2.0 mm (0.0787 in.).

3. Using a T30 "TORX" socket wrench, tighten the "TORX" screw to install the seat position airbag sensor.

   Torque: 8.0 N*m (82 kgf*cm, 71 in.*lbf) 

4. Make sure that the clearance between the seat position airbag sensor and seat rail is between 0.6 mm (0.0236 in.) and 2.0 mm (0.0787 in.).
5. Install the wire harness to the seat slide position sensor protector.
6. Connect the connector.
7. Check that there is no looseness in the installation parts of the seat position airbag sensor.

Refer to PROCEDURE - Step 27 Refer to PROCEDURE - Step 27

Refer to PROCEDURE - Step 28 Refer to PROCEDURE - Step 28

Refer to PROCEDURE - Step 29 Refer to PROCEDURE - Step 29

1. for Manual Seat:

   Refer to INSTALLATION [12/2012 - 08/2016] Refer to INSTALLATION [08/2016 - ]

2. for Power Seat:

   Refer to INSTALLATION [12/2012 - ]

Refer to DTC CHECK / CLEAR [12/2012 - ]

Refer to DIAGNOSIS SYSTEM [12/2012 - ]