Installation [12/2012 - ]: Procedure

INSTALL FRONT SEAT AIRBAG SUB-ASSEMBLY RH
1. Install the front seat airbag assembly LH with 3 new nuts.
  Torque: 5.5 N*m (56 kgf*cm, 49 in.*lbf)
  WARNING:
  - The nuts must not be reused.
  - Make sure that the separate type front seat cushion spring assembly is not deformed. If it is, replace it with a new one.
2. Attach the 3 clamps to the separate type front seat cushion spring assembly.
INSTALL SEPARATE TYPE SEAT CUSHION COVER WITH PAD
Refer to PROCEDURE - Step 17 Refer to PROCEDURE - Step 17
INSTALL SEPARATE TYPE FRONT SEATBACK ASSEMBLY
Refer to PROCEDURE - Step 24 Refer to PROCEDURE - Step 24
INSTALL FRONT INNER SEAT CUSHION SHIELD RH
Refer to PROCEDURE - Step 26 Refer to PROCEDURE - Step 26
INSTALL FRONT SEAT CUSHION SHIELD RH
Refer to PROCEDURE - Step 27 Refer to PROCEDURE - Step 27
INSTALL RECLINING ADJUSTER RELEASE HANDLE RH
Refer to PROCEDURE - Step 29 Refer to PROCEDURE - Step 29
INSTALL FRONT SEAT ASSEMBLY RH
Refer to INSTALLATION [12/2012 - 08/2016] Refer to INSTALLATION [08/2016 - ]
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Refer to INITIALIZATION [12/2012 - 10/2015] Refer to INITIALIZATION [10/2015 - 08/2016] Refer to INITIALIZATION [08/2016 - ]
PERFORM DIAGNOSTIC SYSTEM CHECK
Refer to DTC CHECK / CLEAR [12/2012 - ]
CHECK SRS WARNING LIGHT
Refer to DIAGNOSIS SYSTEM [12/2012 - ]