Removal [11/2015 - ]: Procedure

REMOVE REAR SEAT CUSHION ASSEMBLY
Refer to PROCEDURE - Step 7
REMOVE REAR SEAT CUSHION LOCK HOOK
Refer to PROCEDURE - Step 8
REMOVE REAR DOOR SCUFF PLATE LH
Refer to PROCEDURE - Step 18 [11/2015 - 12/2018] Refer to PROCEDURE - Step 21 [12/2018 - 07/2020] Refer to PROCEDURE - Step 23 [07/2020 -]
REMOVE REAR UNDER SIDE COVER LH
Refer to PROCEDURE - Step 35 [11/2015 - 12/2018] Refer to PROCEDURE - Step 38 [12/2018 - 07/2020] Refer to PROCEDURE - Step 40 [07/2020 -]
REMOVE REAR DOOR SCUFF PLATE RH
HINT:

Use the same procedure as for the LH side.
REMOVE REAR UNDER SIDE COVER RH
HINT:

Use the same procedure as for the LH side.
REMOVE REAR UNDER COVER
- for NICKEL METAL HYDRIDE BATTERY:
  Refer to PROCEDURE - Step 26 [11/2015 - 12/2018] Refer to PROCEDURE - Step 26 [12/2018 - 07/2020] Refer to PROCEDURE - Step 26 [07/2020 - ]
- for LITHIUM-ION BATTERY:
  Refer to PROCEDURE - Step 27 [11/2015 - 12/2018] Refer to PROCEDURE - Step 27 [12/2018 - 07/2020] Refer to PROCEDURE - Step 27 [07/2020 - ]
REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY
- for NICKEL METAL HYDRIDE BATTERY:
  Refer to PROCEDURE - Step 27 [11/2015 - 12/2018] Refer to PROCEDURE - Step 27 [12/2018 - 07/2020] Refer to PROCEDURE - Step 27 [07/2020 - ]
- for LITHIUM-ION BATTERY:
  Refer to PROCEDURE - Step 28 [11/2015 - 12/2018] Refer to PROCEDURE - Step 28 [12/2018 - 07/2020] Refer to PROCEDURE - Step 28 [07/2020 - ]

REMOVE BATTERY COOLING BLOWER ASSEMBLY

Disconnect the battery cooling blower assembly connector.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*A	for NICKEL METAL HYDRIDE BATTERY
*B	for LITHIUM-ION BATTERY

Remove the 3 bolts.

for NICKEL METAL HYDRIDE BATTERY

for LITHIUM-ION BATTERY

Disengage the 2 claws to remove the battery cooling blower assembly.
NOTE:
- Be sure not to touch the fan part of the battery cooling blower assembly.
- Do not lift the battery cooling blower assembly using the wire harness.