LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Prius Two >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Exterior Panels / Trim - Service Information (2 Of 2) >> Front Bumper >> Removal [12/2018 - ] >> Procedure

Removal [12/2018 - ]: Procedure

  1. PRECAUTION 
    1. Change the grille shutter control mode to maintenance mode.

      Refer to INITIALIZATION [11/2015 - ]

      NOTE:

      Make sure to change the grille shutter control mode to maintenance mode to prevent the grill shutter from opening or closing when the power switch is off.

  2. REMOVE RADIATOR SUPPORT OPENING COVER 
    1. Remove the 5 clips.
      GTY872974Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 2 guides and remove the radiator support opening cover as shown in the illustration.
      GTY919055Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction (1)
      Remove in this Direction (2)
  3. REMOVE FRONT BUMPER ASSEMBLY 
    1. Apply protective tape around the front bumper assembly as shown in the illustration.
      GTY848389Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Protective Tape
    2. Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.
      GTY927055Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Pin Hold Clip
      *a 90 deg
      Remove in this Direction (1)
      Remove in this Direction (2)

      HINT: 

      Use the same procedure for the RH side and LH side.

    3. Remove the screw.
      GTY873046Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT: 

      Use the same procedure for the RH side and LH side.

    4. Remove the 10 screws.
      GTY873049Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Disengage the 4 claws as shown in the illustration.
      GTY872517Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Place Hand Here
      Remove in this Direction

      HINT: 

      Use the same procedure for the RH side and LH side.

    6. w/ Intuitive Parking Assist System:
      GTY888645Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A w/ Intuitive Parking Assist System
      *B w/ Pre-collision System
      1. Disconnect the connector.
    7. w/ Pre-collision System:
      1. Disconnect the connector.
    8. Remove the 2 bolts.
      GTY873047Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    9. Remove the 2 clips and front bumper assembly as shown in the illustration.
      GTY899464Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction
    10. Disconnect the 2 connectors.
scientia non olet · About LEMON Manuals