Customize Parameters [06/2017 - ]: Procedure

CUSTOMIZE METER / GAUGE SYSTEM

NOTE:

When the customer requests a change in a function, first make sure that the function can be customized.
Be sure to make a note of the current settings before customizing.
When troubleshooting a function, first make sure that the function is set to the default setting.

HINT:

The following items can be customized.

Customizing with the Techstream

Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Customize Setting / Warning or Display.

Select the setting by referring to the table below.

WARNING

Tester Display	Default	Content	Setting	Relevant ECU
Key Remind Sound*	Slow	Function to change the cycle of the key remind warning buzzer	Normal, Slow or Fast	Combination meter assembly

*: This item is displayed on the Techstream, but does not apply to vehicles with a Smart Key System.

DISPLAY

Tester Display	Default	Content	Setting	Relevant ECU
ODO Display Time After IG OFF Setting	30s	Function to change the ODO display time after the ignition switch is turned off	30s, 60s, 600s or OFF	Combination meter assembly