Caution / Notice / Hint

NOTE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Refer to PRECAUTION [06/2017 - ] ).

HINT:

Perform the simulation method by selecting check mode (Signal Check) using the Techstream (Refer to CHECK MODE PROCEDURE [11/2015 - ] ).
After selecting check mode (Signal Check), perform the simulation method by wiggling each connector of the airbag system or driving the vehicle on a city road or rough road (Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2015 - ] ).