LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Prius C One >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System (Service Information) >> Brake Pedal Stroke Sensor >> Removal [11/2015 - ] >> Procedure

Removal [11/2015 - ]: Procedure

  1. PRECAUTION 
    NOTE:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Refer to PRECAUTION [11/2015 - 06/2017] , or refer to PRECAUTION [06/2017 - ] ).

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    (Refer to REMOVAL [11/2015 - 06/2017] , or refer to REMOVAL [06/2017 - ] )

  3. REMOVE BRAKE PEDAL STROKE SENSOR ASSEMBLY 
    1. Disconnect the connector from the brake pedal stroke sensor assembly.
      GTY329693Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002.
    2. Remove the 2 bolts and brake pedal stroke sensor assembly from the brake pedal support assembly.
      GTY329692Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002.
      NOTE:
      • Do not drop the brake pedal stroke sensor assembly.
      • If the brake pedal stroke sensor assembly has been dropped, replace the brake pedal stroke sensor assembly with a new one.
scientia non olet · About LEMON Manuals