Automatic High Beam Switch Circuit [06/2015 - 11/2018]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Main Body / Data List.
5. Read the display on the Techstream.

   Body Electrical > Main Body > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Auto High Beam Main Switch	Auto high beam switch signal	ON or OFF	ON: Auto high beam switch pressed OFF: Auto high beam switch not pressed	-

   OK

   Normal conditions listed above are displayed.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to  PROBLEM SYMPTOMS TABLE [06/2015 - ] 

Result: 

NG 

See step  2

1. Remove the auto high beam switch.

   Refer to REMOVAL [06/2015 - ]

2. Inspect the auto high beam switch.

   Refer to INSPECTION [06/2015 - ]

   OK

   Combination switch assembly is normal.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE AUTO HIGH BEAM SWITCH. Refer to  REMOVAL [06/2015 - ] 

Result: 

OK 

See step  3

1. Disconnect the G11 auto high beam switch connector.
2. Disconnect the G5 main body ECU (multiplex network body ECU) connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G11-4 - G5-23 (AHBI)	Always	Below 1 Ω
   G11-4 - Body ground	Always	10 kΩ or higher
   G11-1 - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to  REMOVAL [06/2015 - 11/2018] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR