LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander XLE, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Automatic Transmission (UA80F) - Service Information (1 Of 2) (Except Hybrid)) >> Transmission Control Cable >> Adjustment [11/2016 - ] >> Procedure

Adjustment [11/2016 - ]: Procedure

WARNING: This page is about a different car, the 2019 Toyota Highlander, 2018 Toyota Highlander, and 2017 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE CONSOLE BOX ASSEMBLY 

    Refer to REMOVAL [12/2013 - ]

  2. REMOVE NO. 2 SWITCH HOLE BASE 

    Refer to PROCEDURE - Step 31

  3. REMOVE FRONT NO. 2 CONSOLE BOX INSERT 

    Refer to PROCEDURE - Step 32

  4. ADJUST SHIFT LEVER POSITION 
    1. Separate the transmission control cable assembly from the transmission floor shift assembly.
      GTY448162Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, separate the transmission control cable assembly from the transmission floor shift assembly.
      GTY436798Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Counterclockwise
    3. Slide the slider of the transmission control cable assembly in the direction indicated by the arrow in the illustration, and pull the lock piece outward.
      GTY440136Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Slider
      *b Lock Piece
      *c Slide
      *d Pull
    4. Turn the lock nut of the transmission control cable assembly counterclockwise. While holding the lock nut, push in the stopper.
      GTY442280Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Lock Nut
      *b Push in
      *c Stopper
    5. Install the transmission control cable assembly to the transmission floor shift assembly.
      GTY441742Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Stopper
      NOTE:

      After installation, check that the outer part of the stopper is protruding beyond portion A-A as shown in the illustration.

    6. Install the transmission control cable assembly to the transmission floor shift assembly.
      GTY428490Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Lock Piece
      *b Adjuster Case
      NOTE:
      • Check that the lock piece is pulled out.
      • Install the cable end all the way to the base of the transmission floor shift assembly pin.
    7. Push the lock piece into the adjuster case.
      NOTE:
      • Check that the park/neutral position switch assembly and shift lever are in neutral.
      • Securely push in the lock piece until the slider lock is engaged.
      GTY448140Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    8. After adjusting the shift lever position, check the operation and function of the shift lever. If there is a problem, adjust the shift lever position again.
  5. INSTALL FRONT NO. 2 CONSOLE BOX INSERT 

    Refer to PROCEDURE - Step 19

  6. INSTALL NO. 2 SWITCH HOLE BASE 

    Refer to PROCEDURE - Step 20

  7. INSTALL CONSOLE BOX ASSEMBLY 

    Refer to INSTALLATION [12/2013 - ]

scientia non olet · About LEMON Manuals