LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander XLE, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 92 (Engine Control System (2GR-FXE) (Service Information) (Hybrid)) >> Crankshaft Position Sensor >> Removal [02/2014 - 11/2016] >> Procedure

Removal [02/2014 - 11/2016]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. REMOVE COMPRESSOR WITH MOTOR ASSEMBLY 

    Refer to REMOVAL [02/2014 - 11/2016]

  2. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
    2. Remove the bolt and crankshaft position sensor from the cylinder block sub-assembly.
      GTY144955Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      If the crankshaft position sensor has been struck or dropped, replace it.

scientia non olet · About LEMON Manuals