Removal [02/2014 - 11/2016]: Procedure
WARNING: This page is about a different variant/trim than selected.
- REMOVE EGR DELIVERY CHAMBER
Refer to REMOVAL [02/2014 - 11/2016]
- REMOVE CAMSHAFT POSITION SENSOR (for Bank 1)
- Disconnect the camshaft position sensor connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly.
NOTE:
If the camshaft position sensor has been struck or dropped, replace it.
- REMOVE CAMSHAFT POSITION SENSOR (for Bank 2)
- Disconnect the camshaft position sensor connector.
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the bolt and camshaft position sensor from the cylinder head cover sub-assembly LH.
NOTE:
If the camshaft position sensor has been struck or dropped, replace it.