LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander XLE, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical (2GR-FE) (Service Information) (Except Hybrid) (1 Of 2) >> Rear Crankshaft Oil Seal >> Removal [12/2013 - 11/2016] >> Procedure

Removal [12/2013 - 11/2016]: Procedure

  1. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for 2WD) 

    Refer to REMOVAL [12/2013 - 11/2016]

  2. REMOVE AUTOMATIC TRANSAXLE ASSEMBLY (for AWD) 

    Refer to REMOVAL [12/2013 - 11/2016]

  3. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY 
    1. Using SST, hold the crankshaft pulley.
      GTY448235Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • SST: 09213-70011 
        1. 09213-70020
      • SST: 09330-00021 
    2. Remove the 8 bolts, the rear drive plate spacer, the drive plate and ring gear sub-assembly and the front drive plate spacer.
      GTY141703Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE REAR ENGINE OIL SEAL 
    1. Using a knife, cut off the lip of the rear engine oil seal.
      GTY441044Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Protective Tape
      *b Cut Position
    2. Using a screwdriver, pry out the rear engine oil seal.
      NOTE:

      Be careful not to damage the crankshaft.

      HINT: 

      Tape the screwdriver tip before use.

scientia non olet · About LEMON Manuals