Installation [12/2013 - ]: Procedure

1. Install a new clip to the front flexible hose.
   NOTE:

   • Install the clip as far as it will go.
   • When installing the front flexible hose, face the identification mark to the outside of the vehicle.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	Identification Mark

2. Using a union nut wrench, connect the brake line to the front flexible hose while holding the front flexible hose with a wrench.

   Torque: 15.2 N*m (155 kgf*cm, 11 ft.*lbf) 

   NOTE:

   • Do not kink or damage the brake line.
   • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.
   • Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench.

     Refer to PRECAUTION [12/2013 - 11/2016] , or refer to PRECAUTION [11/2016 - ]

3. Engage the 2 claws to install the sensor clamp bracket.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   Do not twist the front speed sensor wire harness when installing it.

4. Install the front flexible hose to the shock absorber bracket with the bolt.

   Torque: 18.8 N*m (192 kgf*cm, 14 ft.*lbf) 

   NOTE:

   The bolt tightens the front flexible hose and front speed sensor together. Make sure that the front flexible hose is positioned over the front speed sensor.

5. Connect the front flexible hose to the front disc brake cylinder assembly with a new union bolt and a new gasket.

   Torque: 30.4 N*m (310 kgf*cm, 22 ft.*lbf) 

   NOTE:

   Install the front flexible hose lock securely into the lock hole in the front disc brake cylinder assembly.

Refer to REPLACEMENT [12/2013 - ]

Torque: 103 N*m (1050 kgf*cm, 76 ft.*lbf)