LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander XLE, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting System (Exterior) - Service Information - (Except Hybrid) >> Rear Combination Light Assembly >> Removal [12/2013 - 11/2015] >> Procedure

Removal [12/2013 - 11/2015]: Procedure

  1. REMOVE REAR COMBINATION LIGHT ASSEMBLY 
    1. Remove the 2 screws.
      GTY425842Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Pin
      *b Guide
    2. Disengage the pin and guide, and disconnect the rear combination light assembly as shown in the illustration.
    3. Disengage the 3 clamps.
      GTY440340Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Turn the rear combination light socket and wire sub-assembly with the tail and stop light bulb as shown in the illustration to disconnect them as a unit.
    5. Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb as shown in the illustration to remove the rear combination light assembly.
      GTY440345Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. REMOVE TAIL AND STOP LIGHT BULB 
    1. Remove the tail and stop light bulb from the rear combination light socket and wire sub-assembly.
  3. REMOVE REAR TURN SIGNAL LIGHT BULB 
    1. Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.
  4. REMOVE DECK BOARD ASSEMBLY 

    Refer to PROCEDURE - Step 1

  5. REMOVE NO. 3 DECK BOARD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 2

  6. REMOVE DECK SIDE TRIM BOX LH 

    Refer to PROCEDURE - Step 3

  7. REMOVE REAR DECK FLOOR BOX 

    Refer to PROCEDURE - Step 4

  8. REMOVE REAR FLOOR FINISH PLATE 

    Refer to PROCEDURE - Step 5

  9. REMOVE REAR NO. 2 SEAT ASSEMBLY 

    Refer to REMOVAL [12/2013 - 11/2016]

  10. REMOVE REAR OUTER SEAT TRACK BRACKET COVER 

    Refer to PROCEDURE - Step 11

  11. REMOVE REAR DOOR SCUFF PLATE 

    Refer to PROCEDURE - Step 12

  12. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP 
    1. Disconnect the rear door opening trim weatherstrip.
  13. REMOVE FRONT DECK SIDE TRIM COVER 

    Refer to PROCEDURE - Step 27

  14. DISCONNECT REAR NO. 1 SEAT OUTER BELT ASSEMBLY 

    Refer to PROCEDURE - Step 11

  15. REMOVE NO. 2 DECK SIDE TRIM COVER (for LH Side) 

    Refer to PROCEDURE - Step 29

  16. REMOVE NO. 1 DECK SIDE TRIM COVER (for RH Side) 

    Refer to PROCEDURE - Step 40

  17. REMOVE DECK TRIM SIDE SERVICE HOLE COVER (for LH Side) 

    Refer to PROCEDURE - Step 30

  18. REMOVE DECK TRIM SIDE BELT HOLE COVER RH (for RH Side) 

    Refer to PROCEDURE - Step 41

  19. DISCONNECT REAR NO. 2 SEAT OUTER BELT ASSEMBLY 

    Refer to PROCEDURE - Step 14

  20. REMOVE SIDE TRIM COVER RH (for RH Side) 

    w/o Rear Automatic Air Conditioning System: Refer to PROCEDURE - Step 43

  21. REMOVE COOLER (NO. 2 ROOM TEMP. SENSOR) THERMISTOR (for RH Side) 

    w/ Rear Automatic Air Conditioning System: Refer to PROCEDURE - Step 1

  22. REMOVE NO. 1 ROOM LIGHT ASSEMBLY (for RH Side) 

    Refer to PROCEDURE - Step 1

  23. REMOVE DECK TRIM POCKET COVER 

    Refer to PROCEDURE - Step 32

  24. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK 

    Refer to PROCEDURE - Step 33

  25. REMOVE ROPE HOOK 

    Refer to PROCEDURE - Step 34

  26. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side) 

    Refer to PROCEDURE - Step 35

  27. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side) 

    Refer to PROCEDURE - Step 49

  28. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY 
    1. Disconnect the connector.
      GTY440473Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the grommet to remove the rear combination light socket and wire sub-assembly.