LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander XLE, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting System (Exterior) - Service Information - (Except Hybrid) >> License Plate Light Assembly >> Removal [12/2013 - ] >> Procedure

Removal [12/2013 - ]: Procedure

  1. REMOVE BACK WINDOW UPPER PANEL TRIM 

    Refer to PROCEDURE - Step 1 , or refer to PROCEDURE - Step 1

  2. REMOVE BACK DOOR TRIM COVER LH 

    Refer to PROCEDURE - Step 2 , or refer to PROCEDURE - Step 2

  3. REMOVE BACK DOOR TRIM COVER RH 

    HINT: 

    Use the same procedure as for the LH side.

  4. REMOVE BACK DOOR LOCK COVER (for Glass Hatch Type) 

    Refer to PROCEDURE - Step 4 , or refer to PROCEDURE - Step 4

  5. REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER 

    Refer to PROCEDURE - Step 5 , or refer to PROCEDURE - Step 5

  6. REMOVE NO. 1 BACK DOOR SERVICE HOLE COVER 

    Refer to PROCEDURE - Step 6 , or refer to PROCEDURE - Step 6

  7. REMOVE BACK DOOR TRIM PANEL ASSEMBLY 

    Refer to PROCEDURE - Step 7 , or refer to PROCEDURE - Step 7

  8. REMOVE LICENSE PLATE LIGHT ASSEMBLY 
    1. Disconnect the connector.
      GTY440352Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disengage the 2 claws to remove the license plate light assembly.
  9. REMOVE LICENSE PLATE LIGHT BULB 
    1. Insert a screwdriver wrapped with protective tape into the license plate light lens hole, tilt it as shown in the illustration and disengage the 2 claws to remove the license plate light lens.
      GTY431237Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Insert into the hole
      Protective Tape
    2. Remove the license plate light bulb.
      GTY440353Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals