Caution / Notice / Hint
NOTE:
- After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [12/2013 - 11/2016] Refer to PRECAUTION [11/2016 - ]
- 2 identical squib connectors are connected to the front seat outer belt assembly RH. The front pretensioner squib RH connector is indicated by the arrow in the illustration.
HINT:
- Perform the simulation method by selecting check mode (Signal Check) using the Techstream.
Refer to CHECK MODE PROCEDURE [12/2013 - ]
- After selecting check mode (Signal Check), perform the simulation method by wiggling each connector of the airbag system or driving the vehicle on a city road or rough road.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [12/2013 - 11/2016] Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2016 - ]