Installation [02/2014 - 11/2016]: Procedure

HINT: 

Perform "Inspection After Repair" after replacing the knock control sensor.

Refer to INITIALIZATION [02/2014 - 11/2016]

1. Install the 2 knock control sensors to the cylinder block sub-assembly with the 2 bolts so that the knock control sensor installation position is as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *A	for Bank 1
   *B	for Bank 2
   *a	Front of Vehicle
   *b	5°
   *c	10°

   Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

   NOTE:

   • If the knock control sensor has been struck or dropped, replace it.
   • Make sure that the knock control sensor is in the correct position.
2. Connect the 2 knock control sensor connectors.

Refer to INSTALLATION [02/2014 - 11/2016]

1. Perform "Inspection After Repair" after replacing the knock control sensor.

   Refer to INITIALIZATION [02/2014 - 11/2016]