LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2016 >> Highlander Limited, FWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Engine Lubrication System (1AR-FE) (Service Information) (Except Hybrid)) >> Oil Pressure Switch >> Installation [12/2013 - ] >> Procedure

Installation [12/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY 
    1. Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly.

      Adhesive

      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      GTY455074Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Adhesive 1344
    2. Using a 24 mm deep socket wrench, install the engine oil pressure switch assembly.

      Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf) 

      NOTE:

      Do not start the engine within 1 hour of installation.

    3. Connect the engine oil pressure switch assembly connector.
  2. INSPECT FOR OIL LEAK 

    See step  5

scientia non olet · About LEMON Manuals