Installation [12/2013 - 11/2015]: Procedure

1. Apply adhesive to 2 or 3 threads of the bolt for the crankshaft position sensor.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Adhesive

   Adhesive

   Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.

2. Apply a light coat of engine oil to the O-ring of the crankshaft position sensor.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   O-ring

3. Install the crankshaft position sensor to the timing chain cover sub-assembly with the bolt.

   Torque: 6.5 N*m (66 kgf*cm, 58 in.*lbf) 

   NOTE:

   • If the crankshaft position sensor has been struck or dropped, replace it.
   • Make sure that the O-ring is not cracked or does not move out of place during installation.
4. Connect the crankshaft position sensor connector.

Refer to PROCEDURE - Step 5

Refer to PROCEDURE - Step 76